Analogue-solutions Nyborg User Manual download pdf (Page 23)

Configuration (contd)

WOODEN SIDE PANELS (OPTIONAL)

These can be fitted to a single Nyborg, or, two Nyborgs that have been bolted together

(see above, ‘Fitting Rack Ears’).

The wood is screwed from the inside. This is so no screws are visible from the outside

which looks far smarter.

FITTING WOOD SIDES

• Unplug From Mains.

• Remove 5 front panel screws.

• Carefully unplug cable internal ribbon. There may be some hot glue securing it.

• Simply pull that off with a pair of pliers.

• Set aside Front panel.

• Put the wood on the table.

• Place the synh on its side on the wood.

Adjust position carefully. Typically set the front of the Nyborg back at least 5mm from

front edge of wood, or just place Nyborg centrally on the wood.

Screw the Nyborg to the wood using self tap screws. It is not necessary to drill any

pilot holes. Be careful not to strip the thread by over tightening.

Repeat for other side.

Then reassemble.

Ensure that you plug the cable back in correctly! The connector is keyed so it is hard,

but not impossible, to plug in incorrectly. Do not force it in.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 29 30

No comments

Analogue-solutions Nyborg User Manual Page 23